AccuQuilt GO! Strip Cutter 2 3/4” (2 1/4” Finished) 3 Strips

Cutting Requirements

• AQ Cutting Mat Required: GO! Cutting Mat – 10" × 24" (25.4 cm × 61 cm)

Patterns You Can Make

Free AccuQuilt patterns designed for this die include:

• GO! Onward Throw Quilt
• GO! Lattice Throw Quilt
• GO! Starry America Throw Quilt

It's also a natural fit for strip quilts, borders, sashing, wide binding, and bag handles.

How to Die Cut with the GO! 2 3/4" Strip Cutter Die

• 2¾" Strips: Cut 8¾" wide fabric strips across the width of fabric to cut three 2¾" strips at a time. Position fabric so the fold is perpendicular to the blades. One yard of 40" wide fabric cuts 12 strips.
• 2¾" Squares: Start with a 2¾" strip. Align it across the die board using the 90° guide line and fanfold into 8¾" widths. One yard of 40" wide fabric cuts approximately 156 squares.
• 45° Diamonds – 3 7/8" cut side edge: Start with a 2¾" strip and align it to the right side of the 45° guide line.
• 30° Diamonds – 5½" cut side edge: Start with a 2¾" strip and align it to the right side of the 30° guide line.
• 60° Diamonds – 3 1/8" cut side edge: Start with a 2¾" strip and align it to the right side of the 60° guide line.

Why Quilters Love the GO! 2 3/4" Strip Cutter Die

• A wider strip than the standard 2½" for borders, sashing, wide binding, and tote bag handles.
• Accurate ¼" seam allowances built into each strip for easy alignment and piecing.
• Printed angle lines turn strips into squares and diamonds with minimal waste.
• 23" long blades are open at both ends so you can cut folded fabric straight from the bolt.
• Layer scraps to cut several strips in one pass.
• Cuts a variety of fabrics: quilting cotton, batiks, flannel, fleece, Cuddle® fabrics, and more.
• Coordinates with the GO! Qube Mix & Match 9" Block.

Recommended Fabric Layers

AccuQuilt Cutting Benefits

• Cut much more fabric in far less time.
• Get accurate cuts every time – no slipping rulers or cutting mistakes.
• Easiest to use – place die on cutter, layer fabric and cutting mat, then send it through.
• Save fabric with Two-Tone Foam by placing fabric only over the shapes you want to cut.
• Safe to use – die blades are embedded in foam, away from your fingers.

Die Tips

• With some fabrics, a thread or two may remain where die blades meet – simply snip with scissors.
• On angled dies, align fabric with the edge of the shape, not the edge of the die board.
• Use quality quilting fabrics to reduce stretch and distortion.
• Always test cut a single shape before mass cutting to confirm fabric orientation.
• Clean lint and threads with an adhesive roller or die pick. Blades never need sharpening.

Dimensions & Specifications